Leveling your Valley Structures Building

 

Leveling Your Valley Structures Buidling

Leveling your Valley Structures storage building begins as we off load the storage shed onto 4 – 4 x 8 x 16 cap blocks, one at each end of the outside skids.  We then place the level on the floor inside the Valley Structures building. We use a jack, sometimes two jacks, to raise the shed until it is level side to side with the highest of the initial 4 blocks. Using a shovel we level off the spots where we place the blocks at the base of each pier. We use only as many blocks as are necessary to be leveled with the highest point. Next we turn the level to check for front to back leveling and adjust the block in the in the piers as necessary to be sure that the Valley Structures building is level both side to side and front to back.

If you choose to watch us complete this task we suggest you watch the doors of your storage building. You will notice as we work that the doors will rise up and down shifting passed each other. Finally as the job is complete you will see that the doors are perfectly lined up.

The size of your Valley Structure building determines how many points we support. The general “rule of thumb” is for supports to be places every 6’ – 8’ along the outside skids and at the ends of the inside skids. The “rule of thumb” may be altered by how you intend to use the Storage Shed, i.e. as a shop with heavy equipment as opposed to general storage. Just talk to our Valley Structures staff and we will be sure the leveling is done to suit your usage. 2. We use the following types of blocks to level your Valley Structures building: 2”, 3”, and 4” “cap” and 8” open web blocks. We use the 4” cap block at the base of each support pier. We never use an 8” open web as the base block since they tend to sink much more quickly. 3. Once the shed is less the 2” out of level we use Pressure Treated decking and Cedar shims to fine tune the leveling. These materials are used due to their ability to with stand the elements. 

 

 

 

 

When you think of roofing, a shell of framed timber probably comes to mind. But there’s also an array of hardware involved in supporting your structure’s roof. Ties and hangers are crucial components, usually made of steel, that are made to resist tension. Let’s a take a look at some varieties.

Rafter Ties

Rafter ties hold together the bottoms of opposing roof rafters, and they’re intended to keep the walls from spreading apart.

Joist Hangers

Joist hangers strengthen a load-bearing connection. These components come in many sizes, dictated by the size of the beam. Experts will agree that using the proper nails—and proper amount of nails—affect the integrity of the installation.

Hurricane Ties

Hurricane ties are often required components in homes in areas prone to severe windy weather. If your residential or commercial buildings need hurricane ties, then you should also consider them for your outdoor structures. Hurricane ties, which are nailed to the bottom of a rafter or truss and connect to the wall plate, work to prevent the uplifting of trusses.

Seismic Ties

Like hurricane ties, seismic ties help hold things together—literally—when things shake up. Regions that could be impacted by an earthquake use seismic ties to secure items to walls. For example: machinery, appliances, desks, filing cabinets or shelving.